What do I do if my hard drive is not detected?
How to confirm whether the hard drive is spinning up or not?
- Boot the computer and try to catch some noise.
- Power off the system.
- Disconnect the power cord from the system.
- Remove the power cable when the hard disk is not detected, or the hard disk you are trying to fix.
- Reconnect the power cord to the system itself.
How do I enable my hard drive in Windows 7?
Connect it to the system and bring up device manager and see if the drive is there listed with a yellow or red icon by it. If it is there like that Right click on it and select enable.
Why is my new HDD not being detected?
The BIOS will not detect a hard disk if the data cable is damaged or the connection is incorrect. Serial ATA cables, in particular, can sometimes fall out of their connection. … The easiest way to test a cable is to replace it with another cable. If the problem persists, then the cable was not the cause of the problem.
What causes a hard drive not to be detected?
If your new harddisk is not detected by or Disk Manager, it could be because of a driver issue, connection issue, or faulty BIOS settings. These can be fixed. Connection issues can be from a faulty USB port, or a damaged cable. Incorrect BIOS settings may cause the new hard drive to be disabled.
How do I enable my hard drive in BIOS?
Restart PC and press F2 to enter BIOS; Enter Setup and check system documentation to see whether the not detected hard drive is turned Off in System Setup or not; If it’s Off, turn it ON in System Setup. Reboot PC to check out and find your hard drive now.
How do I clear up space on Windows 7?
To run Disk Cleanup on a Windows 7 computer, follow these steps:
- Click Start.
- Click All Programs | Accessories | System Tools | Disk Cleanup.
- Select Drive C from the drop-down menu.
- Click OK.
- Disk cleanup will calculate the free space on your computer, which may take a few minutes.
How do I fix SSD not detected in BIOS?
Solution 2: Configure the SSD settings in BIOS
- Restart your computer, and press the F2 key after the first screen.
- Press the Enter key to enter Config.
- Select Serial ATA and press Enter.
- Then you’ll see SATA Controller Mode Option. …
- Save your changes and restart your computer to enter BIOS.