A static route is nothing but a way of specifying traffic that must not go through the default gateway. One can use the ip command for adding a static route to a different network that cannot be accessed through your default gateway. For example, VPN gateway or VLNAN might need to use the ip command.
What is a static route used for?
A default static route is used to send packets when an explicit route is not present in the routing table. This route is configured with 0.0. 0.0/0 as its destination IPV4 address. By configuring a default static route, a router can match all packets to use this route.
What is static route configuration?
Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from dynamic routing traffic. In many cases, static routes are manually configured by a network administrator by adding in entries into a routing table, though this may not always be the case.
Is static IP faster than DHCP?
No, using static addresses is not magically faster than using DHCP addresses. … The same result could be accomplished by putting those two PCs onto the same IP subnet using DHCP rather than static ones.
What is the difference between static and dynamic routes?
A static routing table is created, maintained, and updated by a network administrator, manually. A static route to every network must be configured on every router for full connectivity. … A dynamic routing table is created, maintained, and updated by a routing protocol running on the router.
What does IP route 0.0 0.0 mean?
IP route 0.0. … 0.0 Fa0/0 in plain English means “packets from any IP address with any subnet mask get sent to Fa0/0″. Without any other more specific routes defined, this router will send all traffic to Fa0/0.
How do I enable a static route?
In the WebUI
- Navigate to the Configuration > Network > IP > IP Routes page.
- Click Add to add a static route to a destination network or host. Enter the destination IP address and network mask (255.255. …
- Click Done to add the entry. Note that the route has not yet been added to the routing table.
What is default route IP?
A default route is the route that takes effect when no other route is available for an IP destination address. … The default route in IPv4 is designated as 0.0. 0.0/0 or simply 0/0. Similarly, in IPv6, the default route is specified as ::/0. The subnet mask /0 specifies all networks, and is the shortest match possible.