Quick Answer: How do I enable SATA drive in BIOS?

Why is my SATA drive not detected?

The BIOS will not detect a hard disk if the data cable is damaged or the connection is incorrect. … Be sure to check your SATA cables are tightly connected to the SATA port connection. The easiest way to test a cable is to replace it with another cable.

How do I get BIOS to recognize my hard drive?

Check if the hard drive is disabled in the BIOS

1. Restart PC and enter system setup (BIOS) by pressing F2.
2. Check and switch on hard drive detection in system configurations.
3. Enable the auto-detection for future purpose.
4. Reboot and check if the drive is detectable in BIOS.

How do I fix a SATA hard drive not detected?

To check to see if this is the cause of the BIOS not detecting the hard drive, follow these steps:

1. Power off the computer.
2. Open the computer case and remove the data cable from the hard drive. This will stop any power saving commands from being sent.
3. Turn on the system. Check to see if the hard drive is spinning.

What is UEFI mode?

The Unified Extensible Firmware Interface (UEFI) is a publicly available specification that defines a software interface between an operating system and platform firmware. … UEFI can support remote diagnostics and repair of computers, even with no operating system installed.

Why my hard drive is not showing up?

If your new harddisk is not detected by or Disk Manager, it could be because of a driver issue, connection issue, or faulty BIOS settings. These can be fixed. Connection issues can be from a faulty USB port, or a damaged cable. Incorrect BIOS settings may cause the new hard drive to be disabled.

What do I do if my hard drive is not detected?

How to confirm whether the hard drive is spinning up or not?

1. Boot the computer and try to catch some noise.
2. Power off the system.
3. Disconnect the power cord from the system.
4. Remove the power cable when the hard disk is not detected, or the hard disk you are trying to fix.
5. Reconnect the power cord to the system itself.

How do I get my computer to recognize a second hard drive?

Quick Fix for Second Hard Drive Not Detected In Windows 10:

1. Go to Search, type device manager, and press Enter.
2. Expand Disk drives, find the second disk drive, right-click on it, and go to Update driver software.
3. Follow further updates instructions and your hard disk drive will be updated.

Does it matter what SATA port I use?

If you are installing a single SATA hard drive, it is best to use the lowest numbered port on the motherboard (SATA0 or SATA1). Then use the other ports for optical drives. … Then use the next lowest numbered port for the second drive, and so on.

How do I fix BIOS not booting?

If you cannot enter the BIOS setup during boot, follow these steps to clear the CMOS:

1. Turn off all peripheral devices connected to the computer.
2. Disconnect the power cord from the AC power source.
3. Remove the computer cover.
4. Find the battery on the board. …
5. Wait one hour, then reconnect the battery.

How do I enable SSD in BIOS?

Solution 2: Configure the SSD settings in BIOS

1. Restart your computer, and press the F2 key after the first screen.
2. Press the Enter key to enter Config.
3. Select Serial ATA and press Enter.
4. Then you’ll see SATA Controller Mode Option. …
5. Save your changes and restart your computer to enter BIOS.

How do I fix Windows 10 not detecting my hard drive?

How to fix “Hard drive not detected” on Windows 10?

1. Re-enable the missing drive in the Disk Management.
2. Reconnect the external hard drive.
3. Format the drive.
4. Check the status of the hard drive.
5. Update the driver.
6. Update Windows.
7. Reinstall USB controllers to make the second hard drive recognized.